Straight Trucks
Box Truck (Class B) study guide
A straight truck still needs commercial-vehicle planning. Its enclosed body can hide a shifting load, and its height and rear overhang create hazards that a passenger-car driver may not expect.
Study areas: General knowledge, cargo, inspection, and air brakes when equipped

SECTION 01
Know which license your truck needs
Box truck describes the cargo body, not a license class. A single heavy vehicle may require Class B, while a lighter box truck may not require a CDL unless its passenger use or hazardous-material operation brings it within CDL requirements. Towing can also change the classification.
Check the vehicle and trailer weight ratings and the actual operation before selecting study material. General knowledge is the foundation. Add air brake material if the truck has that equipment, and any endorsement material required by the load.
Key points
- Not every box truck requires a Class B CDL.
- A body style is not a licensing rule.
SECTION 02
Inspect the entire truck
Inspect tires, wheels, brakes, steering, suspension, lights and mirrors before departure. Front tires need at least 4/32 inch tread under the federal rule; other tires need at least 2/32 inch. Look for exposed cords, separation, flat tires and audible leaks even when the tread looks deep enough.
Include the box, door latches, liftgate and any attached equipment. A cargo door can release an unsecured load when opened. Plan a safe place to stand, and do not assume the cargo remained where it was loaded.
Key points
- Tread is measured in a major groove, not over a raised tie bar.
- Secure doors, tailgates and operating equipment.
SECTION 03
An enclosed load still needs restraint
A closed door alone does not establish that cargo is secured. Loads must be restrained by an appropriate combination of the vehicle structure, blocking, dunnage, bars or tiedowns. The structure must be strong enough for the job. Rolling articles need restraints that cannot accidentally loosen in transit.
Distribute the load so it does not compromise steering, braking or stability. Keep emergency equipment and the cab exit accessible. A heavy object that can slide forward during a stop is a hazard even when it cannot fall out of the truck.
Key points
- Enclosed is not the same as secured.
- Keep the driver’s view, movement and emergency access clear.
SECTION 04
Plan clearance and inspection stops
Know the truck’s actual height before approaching bridges, canopies or loading areas. Allow for rear swing and the inside path of the rear wheels when turning. Increase your space cushion as conditions worsen, and avoid abrupt braking or steering around a shifting load.
For accessible cargo, the first securement check is within 50 miles. Later checks occur at duty-status changes and after 3 hours or 150 miles, whichever comes first. Do not open a sealed load contrary to instructions; the regulation addresses sealed and impracticable-to-inspect loads separately.
Key points
- Know your height before the trip.
- Recheck accessible cargo throughout the trip, not just at loading.
Sources and review
Key facts are checked against the federal regulations linked below. Rules can vary by state, so confirm details in your state’s current CDL manual. This is independent study material, not official licensing instruction.
