← All study guides

Cargo Securement

Flatbed study guide

Flatbed safety depends on a securement system that is both strong enough and correctly arranged. Memorizing a tiedown count is not enough: length, weight, forward blocking, attachment method and commodity-specific rules all matter.

Study areas: General knowledge, cargo securement, and the underlying vehicle class

Flatbed truck on the highway hauling large rolls of metal wire

SECTION 01

Start with the article and its movement

Before choosing straps or chains, identify the load’s weight, length, shape and tendency to slide, tip or roll. Rolling articles need chocks, wedges, a cradle or an equivalent restraint. The restraint itself must not become unintentionally loose while traveling.

General securement rules do not replace commodity-specific requirements. Logs, coils, vehicles and other regulated commodities may need particular arrangements. Bulk material with no fixed shape, carried in a structural tank, hopper or similar body, is treated differently from individual articles.

Key points

  • Prevent rolling as well as sliding.
  • Check commodity-specific requirements before using the general rules.

SECTION 02

Count tiedowns with the missing conditions included

For a general article not blocked against forward movement, one tiedown is enough only when it is no longer than 5 feet and weighs no more than 1,100 pounds. If it is 5 feet or shorter but heavier than 1,100 pounds, use at least two. Articles longer than 5 feet and no longer than 10 feet also need at least two.

An unblocked article longer than 10 feet needs two tiedowns for its first 10 feet, plus one for each additional 10 feet or part of 10 feet. When properly blocked against forward movement, the general minimum is one tiedown per 10 feet or fraction. Special-purpose loads and commodity rules can change the arrangement.

Key points

  • A 20-foot unblocked general article needs at least 3 tiedowns.
  • A 20-foot forward-blocked general article needs at least 2 under the general count rule.

SECTION 03

Working load limit is a separate requirement

The aggregate working load limit of the tiedowns must be at least 50% of the weight of the article or group. A 10,000-pound article therefore needs an aggregate WLL of at least 5,000 pounds. Meeting the count rule does not automatically meet the strength rule.

How a tiedown is attached affects the aggregate calculation. A vehicle-to-cargo tiedown counts at half its WLL. A tiedown passing over or around cargo and attached on the same side also counts at half. A tiedown passing over or around the cargo between opposite sides of the vehicle counts at its full WLL. Do not confuse breaking strength with working load limit.

Key points

  • Count and aggregate strength must both be adequate.
  • Attachment method affects how much WLL counts.

SECTION 04

Inspect after the load settles

Inspect the securement before leaving, including anchors, tension, damage and any needed edge protection. A system that was tight at the dock can loosen as the load settles. Stop in a safe location before making adjustments.

Recheck within the first 50 miles, then at changes of duty status or after 3 hours or 150 miles, whichever comes first. Adjust the system as necessary so the load cannot shift or fall. The regulation has limited exceptions for sealed or impracticable-to-inspect cargo.

Key points

  • The first check is within 50 miles.
  • Later checks are triggered by duty status, 3 hours or 150 miles.

Sources and review

Key facts are checked against the federal regulations linked below. Rules can vary by state, so confirm details in your state’s current CDL manual. This is independent study material, not official licensing instruction.

Practice Flatbed