← All study guides

S + P Endorsement

School Bus study guide

Driving a school bus combines vehicle control with responsibility for students who may be difficult to see. Study the passenger and school bus material together, and learn your district’s procedures before operating a route.

Study areas: General knowledge, passengers, school buses, and air brakes when equipped

Students boarding a yellow school bus

SECTION 01

The license is only the beginning

School bus operation requires the appropriate CDL class and the required passenger and school bus endorsements. Endorsements are additional qualifications, not a replacement for the base license. Passenger and school bus endorsements require knowledge and skills tests under federal rules.

A school bus may have air brakes. If yours does, study the air brake material and learn the system on the actual vehicle. A practice score does not establish eligibility, remove restrictions, or replace approved training.

Key points

  • P: passenger endorsement. S: school bus endorsement.
  • Vehicle weight and configuration determine the CDL class.

SECTION 02

Protect students outside the bus

The most vulnerable moments are often before a student boards and after a student gets off. Scan the mirrors and the area around the vehicle before any movement. A student who disappears from view is a reason to stop and account for that student, not a reason to assume the path is clear.

Keep loading and unloading deliberate. Use the signals and stopping procedures required by state law and your district. Avoid backing when you can choose a forward route. If backing cannot be avoided, follow the approved procedure and stop immediately if you lose sight of a lookout. Do not send a student outside to direct the bus.

Key points

  • Account for students before moving.
  • Do not substitute a mirror check for a complete loading-zone procedure.

SECTION 03

Approach railroad tracks as a complete sequence

Under the federal rule for buses transporting passengers, stop between 15 and 50 feet from the tracks, except for the specific exceptions listed in the regulation. Look and listen in both directions, then proceed only when the crossing is clear. State and school district procedures can impose additional requirements.

Choose a gear that allows the entire crossing without a gear change. Do not shift on the tracks. Before entering, make sure there is enough clear space beyond the crossing for the whole bus. A green road signal is not permission to queue on railroad tracks.

Key points

  • 15 to 50 feet is the federal stopping range where the rule applies.
  • No shifting while crossing the tracks.

SECTION 04

Inspect with passengers in mind

A bus inspection includes the usual safety systems plus passenger-related equipment. Check emergency exits and access, seating, mirrors, lights and the equipment required for your operation. Know the evacuation plan before a problem occurs.

Federal tire rules require at least 4/32 inch of tread on front tires and 2/32 inch on other tires, measured in a major groove away from raised features. Buses may not use regrooved, recapped or retreaded tires on their front wheels. Tread depth alone does not make a damaged tire safe.

Key points

  • Keep emergency exits accessible.
  • Check tires for damage as well as tread.

Sources and review

Key facts are checked against the federal regulations linked below. Rules can vary by state, so confirm details in your state’s current CDL manual. This is independent study material, not official licensing instruction.

Practice School Bus